Juniper CTP1000 Series, Руководство по оборудованию

Страница: 58 / 88

CAUTION: To prevent electrostatic damage to the device and its components,
make sure that persons handling the device wear an antistatic device.
Related
Documentation
Before You Install the CTP1000 Platform on page 47
•
•
Installing the CTP1000 Platform in a Rack on page 48
•
Cabling the CTP1000 Platform Overview on page 49
Installing the CTP1000 Platform in a Rack
To install the CTP platform in a rack, you need:
•
Phillips screwdriver
• Four 10-32 x 3/8 Phillips screws for each device to be installed
Follow these guidelines:
1.
Following your installation plan, use a tape measure and marking pen to measure and
mark space on each equipment rack for each platform component. For horizontal
spacing, follow Network Equipment Building System (NEBS) requirements.
2.
With one person standing on the left side of the device and another standing on the
right side, lift the device into the rack.
3.
Position the device in its designated location in the equipment rack. Make sure the
holes of the mounting brackets align evenly with the holes of the equipment rack on
both sides.
4.
Starting at the bottom of the device, secure the device in the equipment rack by using
the 10-32 x 3/8 Phillips screws. Have a third person do this for the larger and heavier
CTP chassis.
5.
Connect the necessary cables. (See “Cabling the CTP1000 Platform Overview” on
page 49 for instructions about installing the cables.)
Related
Documentation
•
Before You Install the CTP1000 Platform on page 47
•
Installing the CTP1000 Platform in Freestanding Mode on page 47
•
Cabling the CTP1000 Platform Overview on page 49
Copyright © 2015, Juniper Networks, Inc. 48
CTP1000 Series Hardware Guide