Juniper CTP1000 Series, Руководство по оборудованию

Страница: 32 / 88

•
Four-post rack—A freestanding open rack, either open or closed
•
The rack must have at least two mounting posts.
• The distance between the mounting holes in the two posts must be 18.31 in. +/-.063
in., as specified in the EIA-310-D document.
•
An optional mounting kit is available for midchassis mounting. Contact your Juniper
Networks sales representative for more information.
Related
Documentation
CTP1000 Rack Requirements on page 21
•
•
CTP1000 Space Requirements on page 22
•
CTP1000 Rack Installation on page 22
CTP1000 Space Requirements
If you use an enclosed rack for the device, ensure that there is a minimum of 3 in. of
clearance between the inner side wall and the system. This clearance space ensures
adequate air flow.
Related
Documentation
CTP1000 Mechanical Requirements on page 21
•
•
CTP1000 Rack Requirements on page 21
•
CTP1000 Rack Installation on page 22
CTP1000 Rack Installation
To confirm proper equipment rack installation, verify the following:
•
Racks are installed and electrically grounded according to manufacturer instructions.
• Equipment racks are anchored to the floor and, when possible, anchored to the ceiling
as well.
•
Equipment rack installations comply with applicable local, state, and national codes.
Related
Documentation
CTP1000 Mechanical Requirements on page 21
•
•
CTP1000 Rack Requirements on page 21
•
CTP1000 Space Requirements on page 22
CTP Cabling Recommendations
We suggest that you comply with the following recommendations:
• Ensure that cable distance and rate limits meet IEEE-recommended maximum speeds
and distances for signaling purposes. For information about attenuation and power
loss in optical fiber cables see:
Copyright © 2015, Juniper Networks, Inc. 22
CTP1000 Series Hardware Guide