Juniper CTP1000 Series, Руководство по оборудованию

Страница: 17 / 88

Figure 6: Wiring a CTP1004 Platform (DC Version)
Power switch
• Do not remove screws or cover.
• Use a magnetic screwdriver and
loosen only two to three turns.
• Insert wires from bottom.
Fork terminal connectors
g015374
Related
Documentation
CTP1002 Platform on page 3
•
•
CTP1012 Platform on page 7
CTP1012 Platform
The CTP1012 platform is a 1-U high, full-rack wide chassis designed for tabletop or shelf
installation. It can also be installed in a rack with the supplied rack-mounting kit. The
CTP1012 device does not have any removable interface modules, but does use a removable
Type II CompactFlash card and is available in an AC-powered version. It has multiple
cooling fans, and airflow is front to back. See
Figure 7 on page 7 and Figure 8 on page 8 .
Figure 7: CTP1012 Platform (AC Version, Front View)
HD P O W E R
C T P10 12
g015379
Power switch USB Flash drive
The front panel comprises the following components (see Figure 7 on page 7 ):
•
Power LED—Green when power is connected and the power switch is set to the ON
position.
• HDD LED—Red when the flash card is in use.
•
Front power switch—Set to
ON
position when
1
is briefly pressed. Set to
OFF
when
1
is
pressed for four or more seconds.
•
Removable flash card—The device must be powered off when you insert or remove
the flash card.
• USB ports.
The rear panel comprises the following components (See Figure 8 on page 8 ):
• Power supply—Uses a standard IEC power cord.
•
Ethernet connection—Provides the 100-Mbps Ethernet connection to the IP network
by means of a local Ethernet switch or router.
7 Copyright © 2015, Juniper Networks, Inc.
Chapter 1: CTP1000 Series Platform Overview