Jungheinrich EZS 330 XL, Руководство по эксплуатации

Страница: 45 / 85

0406
.GB
E 18
6.4 Parameter Settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code (see Section 6.1).
F
Safety notes for trucks with indicator instrument (CANDIS (
o
))
– Parameter settings must be made carefully and only by special trained personnel .
If in doubt, consult the manufacturer's service department.
– Every setting procedure must be monitored on the LC display of the display
instrument (
o
)). If in doubt, the setting procedure must be cancelled by pressing
the
o
key (43)
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the
o
key
– Enter master code
Code Lock Parameters
Setting procedure for trucks without display instrument (CANDIS (
o
)):
– Enter the three digit parameter number and confirm with set key (45).
– Enter the setting according to the parameter list or change and confirm with the Set
key (45).
Z
If the entry is incorrect, the LED (44) of the
o
key (43) goes red. If you enter the
parameter number again the setting can be entered or changed.
To enter more parameters, repeat the procedure. To complete your entry, press the
o
key (43).
Display instrument
(CANDIS)
LED (44)
o
key
LED (40)
Key 1
LED (41)
Key 2
LED (42)
Key 3
Service hours
are displayed
284
.
0
Green
flashing
Off Off Off
0406
.GB
E 18
6.4 Parameter Settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code (see Section 6.1).
F
Safety notes for trucks with indicator instrument (CANDIS (
o
))
– Parameter settings must be made carefully and only by special trained personnel .
If in doubt, consult the manufacturer's service department.
– Every setting procedure must be monitored on the LC display of the display
instrument (
o
)). If in doubt, the setting procedure must be cancelled by pressing
the
o
key (43)
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the
o
key
– Enter master code
Code Lock Parameters
Setting procedure for trucks without display instrument (CANDIS (
o
)):
– Enter the three digit parameter number and confirm with set key (45).
– Enter the setting according to the parameter list or change and confirm with the Set
key (45).
Z
If the entry is incorrect, the LED (44) of the
o
key (43) goes red. If you enter the
parameter number again the setting can be entered or changed.
To enter more parameters, repeat the procedure. To complete your entry, press the
o
key (43).
Display instrument
(CANDIS)
LED (44)
o
key
LED (40)
Key 1
LED (41)
Key 2
LED (42)
Key 3
Service hours
are displayed
284
.
0
Green
flashing
Off Off Off