Julabo Magio MX, Оригинальное руководство по эксплуатации

Страница: 62 / 100

Operation
62
8.7 Remote control device
The device can be connected to a PC via its interfaces and controlled remotely
using a program such as ° EasyTemp. It is also possible to send interface
commands to the device using a terminal.
The respective interface is set up when the remote control is deactivated.
8.7.1 Remote control device using USB interface
The device can be remote-controlled via the standard USB B interface.
 The device is switched off.
 The computer has a terminal program installed.
1. Connect the device (USB plug type B) to the computer with a commercially
available USB cable.
2. Download the suitable USB driver from the download area of the website
www.julabo.com.

Depending on the operating system used by the connected computer, it may
be necessary to install the USB driver.
3. Install the USB driver on the computer.
4. Switch the device on.
5. Call up the
<Main menu> on the device.
6. In the submenu
<Connect unit>/<Remote control>
activate the USB
interface.
 The home screen will show USB mode.
7. Start the terminal program on the computer.
8. Use the terminal program to select the COM port of the device and establish
a connection.

Remote control via the USB interface is activated. This is shown with the
“USB” on the home screen. You can now remotely control the device with
interface commands via the computer.
8.7.2 Set interface parameters
The interface parameters cannot be changed during remote control mode. If
they differ from the factory settings, they must be set before remote control
mode is activated.
 Remote control is deactivated.
1. Call up the circulator on the <Main menu> .
2. From the submenu
<Connect unit>/<Interfaces>
call up the menu
option <Serial> .
3. First select the desired mode.