– 66 –
⁄⁄⁄⁄⁄
Selection of presser lifter switch function (Function setting No. 117)
In the condition when the knee switch is connected, this function is used to select [stop or use] of the automatic
presser lifter function by means of the knee switch.
0: off
The automatic presser lifter is stopped with the knee switch.
1: on
The automatic presser lifter is used with the knee switch.
* Setting is possible only if LH-4168 or LH-4188 is selected for the machin
* When using this function, it is necessary to set up the presser lifter switch half-needle compensation function
(No. 106) to Position 0 (function disabled).
¤¤¤¤¤
Grease up error reset (Function setting No. 118)
When a grease-up error (E220, E221) occurs, this error can be reset by setting the setup description at 1.
0: Normal condition
1: Grease-up error reset when the power is turned on for the next time
(After grease-up error has been reset, this function is also canceled.)
* Prior to resetting the grease-up error, grease-up treatment is always needed.
* Setting is possible only for the machine head (part of the LH-4100 or LH-3500 Series) where grease-up treat-
ments are needed.
‹‹‹‹‹
Main shaft reference angle compensation (Function setting No. 120)
Main shaft reference angle is compensated
Setting range : –35 to 35
°
<1/
°
>
›››››
Correction of upper position stop angle (Function setting No. 121)
Angle to detect UP position starting is compensated.
Setting range : –15 to 15
°
<1/
°
>
fififififi
Correction of lower position stop angle (Function setting No. 122)
Angle to detect DOWN position starting is compensated.
Setting range : –15 to 15
°
<1/
°
>
flflflflfl
Designation of reverse stitching speed (Function setting No.125): This function becomes valid only if the
DDL-9000A is selected.
When reverse stitching is started with the reverse stitching switch or the like, the number of revolutions at the
machine head is reduced to the specified speed.
Setting range: 200 ~ Max. speed
Initial value: 3,300 rpm
7
1
1
0
8
1
1
0
0
-
2
2
1
1
1
2
1
2
2
2
1
0
5
3
3
2
1
0
0
Содержание SC-910N
Страница 1: ...40063908 No E381 00 ENGINEER S MANUAL SC 910N...
Страница 88: ...84 MEMO...
Страница 91: ...87 3 IP 110 operation panel block diagram TM...
