– 27 –
[CP-20]
1
Open the cover, push the smart media until it goes no further, and ease up force when it goes to the
end. The smart media returns by approximately 10 mm in the reverse order of the time of setting.
2
Then draw out the smart media to complete removing.
[CP-20]
Smart media
Be sure to use the smart media that has been formatted with IP-400.
For the formatting procedure of the smart media, refer to
"
@
-2-26. Performing formatting of the media" p.83
.
1
Insert the smart media in the direction as
shown in the figure.
2
After completion of setting of the smart media,
close the cover. By closing the cover, it is
possible to perform communication.
If the smart media and the cover come in
contact with each other and the cover is not
closed, check the following matters.
5) Removing procedure of the media
[IP-410]
Cautions when using the media
• Do not wet or touch it with wet hands. Fire or electric shock will be caused.
• Do not bend, or apply strong force or shock to it.
• Never perform disassembling or remodeling of it.
• Do not put the metal to the contact part of it. Data may be disappeared.
• Avoid storing or using it in the places below.
Place of high temperature or humidity / Place of dew condensation /
Place with much dust / Place where static electricity or electrical noise is likely to occur
1
Hold the panel by hand, open the cover, and press the
media removing lever. The media is eject.
When the lever is strongly pressed, the media
may be broken by protruding and falling.
2
When the media is drawn out as it is, removing is com-
pleted.
• Check that the inserting is stopped in the state that the smart media protrudes by approximately 10
mm.
• Check that the contact part is put downward and inserted.
• Check that the smart media other than 3.3 voltage type is used.
