Judo JRSF Series, Инструкция по установке и эксплуатации

Страница: 33 / 55

Installation and operating instructions: JUDO JRSF automatic backwashing protection filter JRSF-ATP DN 125 - 200 (time and differential pressure controlled)
All rights reserved. JUDO Wasseraufbereitung GmbH
© JUDO Wasseraufbereitung GmbH Postfach 380

D-71351 Winnenden
Translation into foreign languages and reproduction, even in excerpt form, is only permitted with special
approval.
Tel. +49 (0)7195-692-0

Fax +49 (0)7195-692-188
Revision level: 24.05.2017 E-mail: info@judo.eu

judo.eu
33
It must be ensured that the settings of the weekly intervals of the data records belonging
to each other T1 On and T1 Off (TS #01 and TS #02) must be identical!

Press key

to move a display line down to program the desired day(s) of the week.

Key

or

is used to navigate between the desired day(s) of the week, the respective selected
weekday flashes.

Pressing key + or
–
activates or deactivates the selected day(s) of the week (indicated by a
horizontal line).
It must be ensured that the settings of the days of the week of the data records
belonging to each other T1 On and T1 Off (TS #1 and TS #2) must be identical!

Pressing key

again moves down by one display line for programming the finish time of a time-
triggered backwashing process for the timer evaluation of the PLC logic.

Key

or

is used to navigate between the settings for hours, minutes and the function setting,
here the respective selected item flashes.

Pressing key + or
–
programs the desired time as the stop time for T1 Off.
The time for the 2nd record must always be selected to be 1 minute later than the time of
the 1st record of the respective weekly timer (e.g. TS #01 18:30

On, TS #02 18:31

Off)!
It must be ensured that the function setting of the time of data record TS #02 is always
set to

Off!

Press OK
to save the settings for timer T1 Off (“Writing” is indicated in the display).

Press key

to continue to the next menu item “T2 On”.
2.3 Data records weekly timers T2 and T3:
If necessary, the records for timer T2 (TS #03 and TS #04) and timer T3 (TS #05 und TS
#06) must be programmed!
If the functions of the weekly timer T2 or T3 are not required, they must be switched off,
in that either the weekly interval for TS #03 and TS #04 plus TS #05 and TS #06 or all
days of the week for the respective two data records are deactivated (-------)!
If the weekly timers T2 and T3 are required for additional backwashing times, the
programming for this must be performed analogously to that described under 2.1 - 2.2!