Operation
New limit values
Accept <OK>
Confirm the display with
OK
, if the limit
values determined in learning mode are
to be applied.
New limit values
Ignore <OK>
Confirm the display with
OK
, if the limit
values determined in learning mode are
not
to be applied. In this case, the cur-
rently set limit values are then retained.
INFO_NO_HEADER
Monitoring of the limit values also
takes place during the learning mode
phase, based on the limit values that
are actually set.
Exceeding of the set limit value or a
possibly active vacation mode has no
influence on the determination of the
limit values by learning mode.
Learning mode can subsequently
be repeated at any time, e.g. if an
exceptionally high water withdrawal
has taken place during the learning
phase.
4.5
Automatic operation
Water consumption is continuously mon-
itored. If during drawing of water one of
these limits is exceeded, the device shut-off
valve closes.
4.6
Automatic shut-off of the
water supply
CAUTION
After the leakage protection
has closed due to a limit being
exceeded, first check whether
there is a leak before opening the
leakage protection again.
If there is a device for hot water
preparation (in particular a gas or
electrically operated instantaneous
water heater or a heating boiler),
the manufacturer's instructions for
the water heater must be observed
before opening the leakage protec-
tion (instructions for venting).
If one of the set limit values has been
exceeded, the water supply is shut off and
the display shows the type of the limit value
overshoot:
Leakage protect
closed
Water quantity
exceeded
or
Water flow
exceeded
or
Withdrawal time
exceeded
1703593 • 2022/10
JUDO JPCS
21
