JTG JT250 2012, Руководство пользователя

Страница: 66 / 222

20
Oil change
Fig(a): Oil emptying plug Fig(b). Oil filling plug
There is a plug at the bottom of the sump for emptying the
oil
Fig(a) and another plug at the top for filling Fig(b) .
To change the oil, start up the cold engine and let it tick
over for 5 minutes. This will heat the oil enough for
changing.
Then place a tray under the engine and remove the oil plug.
Let all the oil drain out and clean the plug removing any
possible metal filings. When it is clean refit and fill with new
oil through the upper filling plug orifice, until it reaches the
correct level in the peep hole.
AIR FILTER
After removing the filter, it can be cleaned using a
specific degreaser, then washed with water and
detergent, let the filter dry and then coat it with
special air filter oil. It is recommended to check the
state of the air filter regularly, to avoid problems
due to particles in the admission. Make sure you
clean it in a ventilated place, without sparks nearby
and do not use petrol for cleaning, as this could
cause an explosion.