JRC JMA-3400 Series, Инструкция по эксплуатации, Страница: 246 / 314

198
Chapter 10 MAINTENANCE AND CHECK
¾
Rotating section
z
Oiling gears
Apply grease evenly to the tooth surfaces of the main shaft drive gear and the encoder
drive gear with a spreader or brush. Oiling in short intervals is more effective to prevent
the gears from wear and tear and extend their service life, but oil at least every six
months.
Use the grease of Mobilux 2 of Mobil Oil.
z
Driving motor
1) Attenuator
Greasing is not necessary unless there is oil leakage.
2) Motor
The life span of the brush itself is 2000 hours. When the brush is worn out to a half of
the entire length, replace it.
The communicator must be kept clean all the time. If carbon dust is stuck and cannot be
removed with a dry cloth, polish the section with sand paper of No.150 to 400.
The carbon brush can be removed by removing the caps on both sides of the bottom of
the motor.
replacement carbon brushes
Scanner unit
model name
Item name Model name JRC code
JMA-3406 Carbon brush 54531-01 BRXP05247
z
Mounting legs
Check the mounting legs and mounting bolts of the scanner unit case for corrosion at
intervals and maintain them to prevent danger. Apply paint to them once a half year
because painting is the best measure against corrosion.
10.2.2 DISPLAY NCD-2364
DANGER
When cleaning the display screen, do not wipe it too strongly with a dry
cloth. Also, do not use gasoline or thinner to clean the screen.
Failure to comply will result in damage to the screen surface.
Dust accumulated on the screen will reduce clarity and darken the video.
For cleaning it, wipe it with a piece of soft cloth (flannel or cotton).
Do not wipe it strongly with a piece of dry cloth nor use gasoline or thinner.
Carbon brush
Communicator contact side
Spring