JRC Alphatron Marine AlphaDynaPos, Руководство по эксплуатации

Страница: 62 / 86

62 | Operation
2.4.10.4 Change Heading Alarm Limit
The system can be set up to activate an alarm when heading cannot be kept. The difference between the Actual Heading
compared to the Set Heading must be larger than the alarm limit to activate an alarm.
To change Heading Alarm Limit, perform the following actions:
1. Locate the ALARM limit display in the lower left of the screen in the HEADING angle display area (Figure 61: Alarm
Limit Display on page 67).
2. Double click on the yellow digits that display alarm limit currently set.
A dialog box appears with digit buttons to enter the alarm angle.
3. Press OK to confirm.
2.4.11 Auto Position Mode Settings
The settings for controlling auto position are located in the lower right of the screen (Figure 20: DP MAP Screen on page
32).
This area displays the actual position and settings that can be used to change the holding position.
Figure 52: Auto Position Mode Settings Figure 53: Joystick Buttons Left
2.4.11.1 Auto Position Mode
Before activating the Auto Position mode, the system must be in control and one or more position sensors must be
selected.
1. Press CTRL button on the joystick panel to take system in control (Figure 53: Joystick Buttons Left on page 62).
2. Take position sensor in control on Position Screen, see Position Sensor Calibration and Selection on page 59.
3. Turn to Auto Position mode using buttons on the joystick panel.
2.4.11.2 Change Position Set Point
The Position Set Point may be changed via different methods. These methods are only available if the system is in auto
position mode.
To change Position Set Point to the actual position perform the following actions:
1. Locate the CURRENT POSITION button at the lower right of the screen.