TRANSFER A MODEL TO THE X9303 2.4 – (Transfer function) – To Receive
H-8
1. Hold the
ENT
button while plugging the trainer cord
into the back of the transmitter to obtain the
SYSTEM
Menu. Plug the other end of the trainer cord into
another X9303 2.4 or XP9303 transmitter while
holding the
ENT
button and prepare that transmitter
for Transmit as described above. Or, plug the other end
of the trainer cord into a DataSafe unit and prepare the
DataSafe for Transmit.
2. Highlight and select
TRANSFER
in the
SYSTEM
Menu
to obtain the Transfer display.
3. If
RECEIVE
is already displayed, continue with the next
step. If
TRANSMIT
is displayed, highlight and select
TRANSMIT
, changing it to
RECEIVE
.
4. Select the model memory that is to receive the data by
highlighting and selecting the model name/memory
number and then scrolling to and selecting the model
memory that is to receive the data. Be careful to select
an unused model memory or a memory that contains
data for a model that is no longer needed because the
data in this model memory is going to be replaced by
what is transmitted and will be permanently lost.
Note
: The receiving model name/memory number
can not be the currently selected model. If you wish to
receive a model in the currently selected model name/
memory number, go to the model select function and
select a different model, then re-enter the transfer
function and follow the instructions above.
5. Press the
CLR
button next to
START
on the left side
of the display. Stand-by appears at the bottom of
the display indicating that the X9303 2.4 is ready to
receive data. Press start on the transmitting X9303 2.4,
XP9303 or DataSafe unit to begin the data transfer to
the X9303 2.4.
[TRANSFER]
RECEIVE
MODEL 4 HELI
MODEL 3
Connect DSC & POWER off
