JR Voyager E, Руководство по сборке

Страница: 11 / 72

2-1
2-2
Short
Long
Main Rotor
Shaft
Main Shaft Collar
3 x 3 mm Set Screw (2)
Autorotation Collar
Main Drive Gear/
Autorotation Assembly
2.6 x 15 mm Socket Head Bolt
................................. 2 pcs
............... 1 pc
................................... 1 pc
3 x 3 mm Set Screw
2.6 x 15 mm Socket Head Bolt
2.6 mm Lock Nut
Washout Assembly
Anti-Rotation Plate
120 CCPM Swashplate
2.6 x 8 mm Self Tapping Screws (4)
.................................... 4 pcs
2.6 x 8 mm Self Tapping Screw
Use Threadlock
11
Main Drive Gear Assembly Installation
Swashplate and Washout Assembly Installation
Mount the autorotation collar on to
the autorotation assembly hub so that
the holes are aligned properly. Please
note the correct direction of the
collar during assembly.
If it is difficult to insert the main drive gear
assembly, loosen the 4 screws in the lower
main shaft bearing block and push the
block down slightly. Retighten the screws
when completed.
Lift the main shaft collar upwards
and secure to the main shaft
using the 2 set screws. It will be
necessary to align these set screws so that they
are accessible through the hole in the side of the
main frame. While securing the set screws,
make sure that you are pushing down on the
main rotor shaft so that there will be no up/down
play in the main shaft once the collar is secured.
Slide the swashplate assembly and the
washout assembly onto the main rotor
shaft. Next, install the antirotation plate
so that the long pin located on the lower
swashplate ring engages into the grove
of the plate as shown.
Attach the 2 washout links to the top of
the swashplate ring as shown in the
diagram to the right.