JR Voyager E, Руководство по сборке

Страница: 33 / 72

33
1) Connect the power supply and press the Power button to light the LED. Keep pressing the button until
the light is off. After that, the light blinks slowly.
Make sure to raise the pinion gear installed in Step 3-7 as the motor
can/will rotate at this time. When this procedure is finished, remove
the motor and battery connector for precaution.
Please refer to the instructions below for proper speed controller adjustment.
Important: Prior to connecting the NiCad batteries, please check to insure that the motor pinion gear does
not engage the intermediate gear. Once the speed controller valves have been set, connect the motor leads to
the speed controller.
After the speed controller has been adjusted as shown below, verify that the motor is completely stopped with
the throttle stick in the low position.
Once this has been established, disconnect the NiCad battery pack.
Do not reset the motor pinion at this time. This will be be done after all radio adjustments have been made.
2) Set the throttle stick to the lowest position and the throttle trim to the neutral position. Press the Power
button once to blink the LED twice. This indicates that motor is off.
3) Set the stick to the highest position. Press the Power button once. The LED will be on followed by a
quick blink.
4) When the settings are done, keep pressing the Power button until the LED is off. Then turn the power
supply off.
SPEED CONTROLLER SETUP
Power Button
LED
Once this has been completed, disconnect the battery pack from the speed controller. Disconnect the motor leads at this time.
Motor leads to speed controller