JR ProPo PCM9XII, Инструкция по эксплуатации

Страница: 27 / 88

MacGregor Industries
23 HELI
To set a transition delay, highlight "Delay" by rotating the Scroll Bar and click on it to bring up the sub menu. The
wording is surrounded by a box to indicate that it is selected. Rotate the Scroll Bar to alter the setting. Figures between
INH (inhibited) and 2 seconds may be entered. To return to INH (inhibited), press the clear (CLR) key at the left hand side
of the screen. When the required setting is achieved, click the Scroll Bar to exit the sub menu.
Press the LIST key to return to the Function Menu. Press the enter (ENT) key to return to the Information Display Screen.
Throttle Curve
The Function Menu List is accessed from the Information Display Screen by pressing the LIST key. From the Function
Menu List, rotate the Scroll Bar to highlight the "THRO CURV" menu choice and click the Scroll Bar.
The PCM9XII offers up to five separate Throttle curves with up to seven adjustable points in each (high, low and five
intermediate points). The Throttle curve can be tailored to suit the engine torque curve and so maximise engine
performance. The curves are selected by the Flight Modes.
Please note that the Throttle Trim and Hovering Throttle levers are only active when the Flight Mode switch is in
the NORMAL position.
Input and output monitor figures are displayed at the bottom left of the screen. The IN figure represents the Throttle stick
position (input), with zero being at one extreme, 50 being the centre and 100 being the other extreme. The OUT figure
represents the Servo (output) position, with zero being at one extreme, 50 being the centre and 100 being the other extreme.
With a linear response, the figures move together and with a curved response, the output follows the non-linear curve.
To select the Throttle curve screen, highlight "NORM" (or previous curve) at the top left of the screen by rotating the
Scroll Bar and click on it to bring up a browse box of the available curves. Rotate the Scroll Bar to highlight the required
curve and click to select. The new curve appears in the screen. Please note that stunt modes ST-3 and ST-4 will only
appear if F.MODE EXTRA has been enabled in System Mode - DeviceSEL.
To select an exponential (smoothed) curve, highlight the OFF adjacent to EXP by rotating the Scroll Bar and click on it
to toggle between OFF and ON. Notice that the displayed graph changes to reflect the new condition.
To set a Throttle curve point, highlight the required point by rotating the Scroll Bar and click on it to bring up the sub
menu. The highlighting is surrounded by a box to indicate that it is selected. Rotate the Scroll Bar to alter the setting.
When the required setting is achieved, click the Scroll Bar to exit the sub menu. For mix points 0, 3 and 6, to return the
figures to the default of zero, press the clear (CLR) key at the left hand side of the screen. For mix points 1, 2, 4 and 5, the
clear key (CLR) at the left side of the screen returns the mix point to inhibited (INH). Notice that the displayed graph
changes to reflect the figures entered.
Note that an inhibited mix point plays no part in the mixing procedure. This is most noticeable when using the exponential
(EXP) feature to smooth the curve. To activate the inhibited mix points, click on them twice (once to activate and once to
exit). The "hidden" value will appear and the mix point will become active.
The figure to the right of [THRO. CURV] to the top left of the screen indicates the current Flight Mode switch position.