JR ProPo PCM9XII, Инструкция по эксплуатации

Страница: 25 / 88

MacGregor Industries
21 HELI
To change the sub trim value, highlight the required channel by rotating the Scroll Bar and click on it to bring up the sub
menu. The highlighting is surrounded by a box to indicate that it is selected. Rotate the Scroll Bar to alter the setting. To
return the figures to the default of zero, press the clear (CLR) key at the left hand side of the screen. When the required
setting is achieved, click the Scroll Bar to exit the sub menu.
Note: when CCPM is selected, the CCPM channels will be re-named. (CH2, CH3, CH6, CH8)
Press the LIST key to return to the Function Menu. Press the enter (ENT) key to return to the Information Display Screen.
Travel Adjust
The Function Menu List is accessed from the Information Display Screen by pressing the LIST key. From the Function
Menu List, rotate the Scroll Bar to highlight the "TRVL ADJ." menu choice and click the Scroll Bar.
Travel Adjust, (Endpoint Adjustment/Travel Volume), sets the movement of the servo arm. The travel adjust range is from
zero to 150% with individual adjustment in each direction. The adjustment is for the individual servo and when two servos
are controlled from a single stick (Ailerons say), the Dual Rate function should be used to set the movement, so that the
travel of both servos is adjusted together
To set a travel value, highlight the required figure by rotating the Scroll Bar and click on it to bring up the sub menu. Pairs
of figures are surrounded by a box to indicate that they are selected. Move the control stick to swap between the right/left,
up/down figures and rotate the Scroll Bar to alter the setting. To return the figures to the default of 100%, press the clear
(CLR) key at the left hand side of the screen. When the required setting is achieved, click the Scroll Bar to exit the sub
menu.
Press the LIST key to return to the Function Menu. Press the enter (ENT) key to return to the Information Display Screen.
Swash Travel
Please note that Swash Mix only appears if CCPM has been activated in the System Menu - SWASH TYP.
The Function Menu List is accessed from the Information Display Screen by pressing the LIST key. From the Function
Menu List, rotate the Scroll Bar to highlight the "Swash Mix" menu choice and click the Scroll Bar.
The travel of the Aileron, Elevator, and Pitch CCPM movements may be set in the Swash Mix section. The default is to
have the travel reduced to 60%. Negative values may be set and they cause the servo movements of the associated
CCPM channels to be reversed. An exponential movement may be selected that helps to remove the non-linear action of
the swashplate due to the mechanical differential of the servo horns.