6
Only use connection cables marked
H05VV-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
5.4 Dust connection
Before initial operation, the machine
must be connected to a dust
extractor.
5.5 Starting operation
You can start and stop the machine
with the ON/OFF-button(A).
Fig 4
In case of machine overload the
motor overload cut-off (B) will react.
After appr.5 min of cooling the
overload cut off can be reset.
Attention: The machine will start
when you reset the overload push
button!
6. Machine operation
Correct operating position:
To feed the workpiece into the
machine, position yourselves offset
to one side of the feed opening.
Workpiece handling:
Adjust the planer table to the
workpiece thickness.
Fig 5
Feed workpiece slowly and straight
into the thicknesser. It will then be
automatically fed through the
thicknesser.
Guide workpiece straight through
the thicknesser.
To remove the workpiece from the
machine, position yourselves offset
to one side of the outfeed opening.
Support long workpieces with
helping roller stands.
Operating notes:
Always use sharp cutter knives!
Feed with thicker workpiece end at
the front, hollow side downward.
Max. 2,5mm depth of cut.
If a workpiece gets stuck raise the
cutterhead by app. 1mm (1 crank
turn).
Plane the stock with the grain, if
possible (Fig 6).
Fig 6
You get a better surface when
planing several passes with less
chip removal.
Switch machine off if no further
planning is to be done immediately
afterwards.
Workpieces shorter than 250mm
may not be processed.
Machine max. 2 workpieces at one
time. Feed on both outer sides.
7. Changing cutter knives
The cutter knives may
only be changed when
the mains plug is pulled!
Risk of personal injury by cuts from
the cutter knives. Wear suitable
gloves when changing cutter knives.
Knife removal:
Raise the cutterhead to its highest
position.
Remove the thickness crank (E) and
the planer cover screws(K).
Fig 7
Remove the planer cover.
Remove the cutter block cover (L)
Fig 8
Turn the hex-head bolts (M) of the
cutter knife lock bar all the way in
(wear gloves!).
