Jøtul GI 545 DV MV, Инструкция по установке и эксплуатации

Страница: 3 / 36

3
139919 GI 545 DV and DV MV 5/19
�
Figure 1.1
Pull each Spring Latch OUT and UP to
disengage it from the Glass Frame.
INSTALLER NOTE:
Please give this manual to the homeowner and
instruct them on basic operation procedures
before leaving the premises.
Table of Contents
1. Unpacking the Fireplace ......................... 3
2. Specifications .............................................4
3. General Information ................................. 5
4. Safety Information ..................................6
5. Installation ............................................ 7
5.1 Fireplace Requirements ...................... 8
5.2 Hearth and Clearance Protection .....8
5.3 Clearances ...............................................9
6. Vent Guidelines ................................. 10
6.1 Masonry Fireplaces ............................ 11
6.2 Factory-built Fireplaces ......................12
6.3 Vent Connection .................................13
7. Fireplace Assembly ..............................14
7.1 Gas Connection .................................. 14
7.2 Gas Pressure Test ............................... 14
7.3 Fuel Conversion .................................. 16
7.4 Optional Controls .............................. 18
7.5 Firebox Panels ................................... 19
7.6 Traditional Log Set ........................... 20
7.7 Beach Fire Log Set .............................22
7.8 Backer Plate Installation ..................24
7.9 Trimable Backer Plate .......................24
7.10 Decorative Front Overlay .................25
8.
Operation ...........................................26
8.1 Fireplace Operation ............................26
8.2 Blower Operation ..............................28
8.3 Thermostatic Operation ..................28
9. Maintenance ......................................28
9.1 General and Annual Cleaning ..........29
9.2 Glass Care and Replacement ...........29
10. Illustrated Part Breakdowns ...............30
11. Appendix .......................................... 32
11.1 Approved Vent Manufacturers ......32
11.2 Warranty Statement ......................... 33
12. Lighting Instructions ............................. 35
1.0 Unpacking the Fireplace Insert
1. Thoroughly inspect the shipping crate and fireplace for
damage and immediately contact the dealer if any is
found.
2. The Log Set and optional Blower are shipped separately
from the firebox. Do not install these untill directed in
these instructions.
A Miscellaneous Hardware Kit is packed within the firebox
crate with this manual. Confirm these contents:
• Fuel Conversion Kit, LP
• Fireplace Conversion Notice Plate
• Rock Wool Ember Fibers
• Safety Screen Barrier Guidelines
3. Detach the firebox from the pallet with removal of the
attachment bracket screws at each side of the firebox base.
4. Remove the Latch Tool from the shipping pallet. Use it to
disengage the two spring latches from the glass frame
as shown in fig. 1. Engage the tool prong with the Latch
receiver hole and pull the latch hook forward and up to
disengage it from the glass frame slot. Pivot the top of
the frame forward and lift to disengage it from the glass
frame channel at the bottom of the firebox. Set the glass
assembly well out of the way.
5. PRE-INSTALLATION FIT UP: Leveling bolts are located at
each corner of the firebox base to allow a maximum 1/2”
adjustment to correct hearth irregularities.
Before assembly, locate the firebox in its final position
within the fireplace and adjust the leveling bolts as
necessary to level and plumb the unit. Pull the unit back
out of the fireplace and read the installation requirements
in this manual before proceeding with final assembly and
installation.