19
139262 Rev_H
9 / 11 / 2012
Figure 20. Glass and Gasket Replacement
Description
Part Number
1.
Door Gasket
223858
2. Glass Gasket
200024
3. Gasket Clamp
224257
4. Screw, M6x10 Button Hd. 117978
5. Lower Glass Clip Asy,
157357
6. Glass Panel
224158
7. Upper Glass Clip Asy.
157352
6.3 General Care
As with your car, regular maintenance will assure good
performance and prolong the life of your stove. The
following procedures do not take long and are generally
inexpensive. When done consistently, they will increase the
life of your stove and in turn,provide years of enjoyment.
•
Regularly empty the stove of all soot and ashes. Only
use a vacuum for this job if the vacuum is specifically
designed to handle ashes.
CAUTION: Ashes can contain
live embers. Be certain the ash bed contains no live
embers before using a vacuum.
•
Inspect the stove: Using a strong light inspect the stove
inside and out for cracks or leaks.
•
Replace any broken bricks. See fig. 29, page 24. DO NOT
OPERATE THE STOVE WITH BROKEN OR MISSING BRICKS.
6.4 Gasket Replacement
1. Use pliers and a putty knife to remove the old gasket and
adhesive from the door.
2. Thoroughly clean the channel with a wire brush.
3. Apply a small bead of cement to the channel.
4. Gently press the new gasket into the cement to seat it in
the channel. Wrap the two ends around and secure with
the gasket clamp as shown in fig. 20. Close and latch the
door and then reopen. Wipe away any excess cement
that may have squeezed out from around the gasket.
6.5 Glass Removal or Replacement
See fig. 20.
1. Place the door face down on a protected surface.
2. First just loosen each glass clip screw and then remove
the clips.
3. Lift the glass panel out of the door. Use pliers and a
putty knife to remove the old glass gasket. Replace with
PN 200024, .025 dia. LD2 gasket. Apply a small bead of
cement in the channel and gently press the gasket into
place.
4. Replace the glass and glass clips. Tighten the clips
gradually, avoiding placing uneven pressure on the glass.
6.6 Chimney System
The Jøtul F
50
TL is designed to burn cleanly and efficiently
when used according to the guidelines in this manual. In
order to maintain proper performance, you should inspect
the chimney and chimney connector at the beginning of
each heating season and then every eight weeks during
the heating season. Clean the chimney whenever creosote
and fly ash accumulation exceeds 1/4 inch in any part of the
system. If the stove. Also, use a shop vacuum to remove any
debris that may have accumulated on the stove baffle.
Chimney brushes are available from your local Jøtul dealer
or hardware supply store. Your dealer can also refer you to a
reputable, professional chimney sweep who will have all the
equipment to ensure a complete and proper job.
WARNING: FAILURE TO KEEP THE CHIMNEY CONNECTOR
AND FLUE FREE OF CREOSOTE BUILD-UP CAN RESULT IN A
CHIMNEY FIRE.
