21
9.
DATA LOGGING RESET
9.1
The frequency of the clean cycle operation continuously displayed on the
LCD is also stored in a non-volatile memory by the controller. The user
can reset the data logging memory to zero. To reset the data, power up
the unit or push the RESET button. After doing this, the following
messages will be displayed:
GI-2000 Grease Interceptor
SOFTWARE VERSION 6.2
9.2
If the ENTER button is not pressed within 5 seconds the unit will revert to
the automatic or manual mode. If the ENTER button is pressed within the
5 seconds the following message will be displayed:
PRESS ENTER AGAIN TO RESET
CLEAN CYCLE DATA LOGGING
9.3
If the ENTER button is pressed within 5 seconds the data log will be reset
and the following message will be displayed:
CLEAN CYCLE DATA LOGGING
HAS BEEN RESET
9.4
Within a few seconds the system will return to automatic or manual display
mode.
PRESS ENTER TO RESET
CLEAN CYCLE DATA LOGGING
