D-308495 PGP914 Rev.0
Configuring the temperature alerts
You can configure the temperature alerts with the settings described in the following table.
Table 2: Temperature alert configuration options
Option
Action
Threshold
Displays the last saved threshold value and provides the
installer with the ability to change the value using the back or
next button.
Disable/Enable
Define whether the panel reports an alert or not.
Alert delay
Define the amount of time the panel waits before an alert is
reported when the temperature exceeds the defined default.
The alert delay time values are:
Immediately
,
1 min
,
2 min
,
10
min
(default),
15 min
,
20 min
,
30 min
.
Restore delay
Define the amount of time the panel waits before an alert is
reported when the temperature exceeds the defined default.
The restore delay time values are:
Immediately
,
1 min
,
2 min
,
10 min
(default),
15 min
,
20 min
,
30 min
.
Opening and closing the device cover
1.
To open the device cover, loosen the cover screw located on the underside of the device. See
A1 in the following figure.
Figure 3: Device cover removal
2.
Push in the tab on the underside of the device and pull the cover upwards. See A2 in the
previous figure.
3.
To close the device cover, clip the cover onto the device base and tighten the cover screw.
PGP914 Wireless PIR Motion Detector Installation Guide
5
