![background image](http://html.mh-extra.com/html/johnson-controls/pgp914/pgp914_installation-manual_2024421007.webp)
D-308495 PGP914 Rev.0
Removing the pet mask
Remove the pet mask if you do not require pet immunity.
1.
Open the device cover. See Figure 3.
2.
Remove the tabs at the sides of the pet mask from the holes on either side of the PIR sensor.
See A1 in the following figure.
3.
Remove the tabs at the base of the pet mask from the holes below the PIR sensor. See A2 in
the following figure.
4.
Gently lift the pet mask.
Figure 6: Removing the Pet Mask
5.
Close the device cover. See Figure 4.
Mounting the device using tape
1.
Ensure the plug is attached to the back of the corner bracket. See Figure 9.
2.
Peel the release liners off the two strips of double-sided adhesive tape and attach the tape to
the back of the bracket. See Figure 7. Use option A for flat surface mounting and B for corner
surface mounting.
PGP914 Wireless PIR Motion Detector Installation Guide
7