D-308495 PGP914 Rev.0
Figure 11: Attaching the device to the corner bracket
Disassembling the device from the bracket
1.
Open the device cover. See Figure 3.
2.
Remove the battery.
3.
Use a screwdriver to press on the stopper snap to release the device base from the bracket.
See A1 in the following figure.
4.
Slide the device downwards to remove it from the bracket. See A2 in the following figure.
Figure 12: Disassembling the device from the bracket
Replacing the battery
Note:
The device transmits a low battery signal upon detection of low voltage. It is
recommended to wait about 1 minute after battery removal before inserting the new battery.
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the manufacturer's instructions and according to local rules and
regulations.
1.
Remove the device cover. See Figure 3.
2.
Remove the battery. See A in the following figure.
3.
Insert the new battery while observing battery polarity. See B in the following figure.
10
PGP914 Wireless PIR Motion Detector Installation Guide
