John Bean BFH 1000, Руководство по эксплуатации

Страница: 12 / 46

Page 6
1.8 INSTALLATION AREA REQUIREMENTS
Make sure that from the operating position the user can see all of the machine and the surrounding area.
The operator should prevent non authorized persons and/or objects from entering the area which may create
potential hazards.
The machine should be installed on a stable level floor. Do not install the machine on a uneven floor.
If the balancer is to be installed on a raised floor, the floor must have a capacity of at least 110lbs per sq ft. (5000
N/m² - 500 kg/m²).
It is not required to secure the machine to the floor but is recommended.
Install the machine in a dry, covered area.
The installation of the machine requires a working area of at least 64” x 64” (1626 x1626 mm). See Figure 3
1.9 INSTALLATION PRECAUTIONS
CAUTION! CAREFULLY REMOVE THE BALANCER FROM THE PALLET.
Remove the hardware that secures the machine to the pallet and slide the balancer onto the floor where it is
to be installed.
THE UNIT IS HEAVY AND THE WEIGHT IS NOT EVENLY DISTRIBUTED.
DO NOT LIFT THE BALANCER BY THE SHAFT OR WHEEL GUARD FRAME.
DROPPING THE UNIT MAY CAUSE PERSONAL INJURY OR EQUIPMENT DAMAGE.
2.0 INSTALL ACCESSORY PINS
A. Install the accessory pins (Figures 4a and 4b). Tighten firmly.
B. Install the Cone Accessory tray if installing a BFH 1000 Super Model. See Figure 4b.
C. Place accessories onto the accessory pins or place 7 cone set into tray if installing a BFH 1000 Super.
Figure 4a - BFH 1000 Figure 4b - BFH 1000 Super