12
Joerns® Bed Frames
EasyCare
®
© 2015 Joerns Healthcare • 6110158 RevC • 15-2537
EasyLift Leg Positioner Operation
1. To raise: Grasp the bed’s foot deck and raise to
the desired position (Figure 30).
2. To lower: Grasp the foot end of the bed’s deck and
raise ½-inch to ¾-inch above present notch, then
lower gently;
3.
Or, grasp the foot end of the bed deck, raise to the
highest position, and lower gently.
Servicing
Power Cord and Grounding Connectors
Inspection of power cord and grounding connectors
(if present) should be conducted on a yearly basis to
ensure efficient bed operation.
1. Check the power cord to make sure it has
not been damaged. If the power cord needs
replacement due to damage, remove the bed
from use/service until the power cord has been
replaced.
2.
Check the grounding connectors (if present)
to ensure they remain intact and are securely
fastened to their intended connection point.
Actuator and Control Box Information
Warning: Possible Shock Hazard.
Unplug the
power cord from the wall outlet before performing any
maintenance/service to the control box.
Note:
Overload protection is achieved via current
sensing technology, which will reset automatically if
any bed function fails to operate. Ensure that the bed
is not overloaded or constrained from movement.
Actuator And Control Box Identification
Cable and Port Identification (Figures 31 and 32)
1.
Foot Leg Hi/Low Actuator (red)
2.
Back Actuator (yellow)
3.
Head Leg Hi/Low Actuator (orange)
4.
Knee Actuator (blue)
5.
Control Harness (green)
6.
Emergency Battery Pack
7.
AC Power
Note:
The Actuators and Control Box contain no
serviceable parts. Overload protection is achieved via
current sensing technology, which will automatically
reset. If any bed function fails to operate, check to
see if the bed is overloaded or constrained from
movement.
Figure 30
1
2
3
4
HB
Figure 31
Figure 32
6
7
