7
Joerns® Bed Frames
EasyCare
®
© 2015 Joerns Healthcare • 6110158 RevC • 15-2537
Caution:
Carefully remove the packaging straps
(orange zip ties) before attempting to operate the bed.
Installation Of Baseboard Bumper
Recommended Tool: Rubber mallet
1.
Place the baseboard bumper as shown (Figure 7).
2.
Tap into place with a rubber mallet or press firmly
with the sole of your shoe until it locks into place
as shown (Figure 8).
Installation Of Baseboard Bumper
(Advanced Staff Control)
Recommended Tool: Rubber mallet
The bed will ship with the standard bumper installed.
If the 12° Trendelenburg Mode is enabled (optional) it
will be necessary to remove the installed bumper and
install the 12° bumper.
Note:
The 12° bumper can be
identified by a silver label with “12°” printed on it. It is
longer than the standard bumper.
1.
Remove the shorter bumper by tapping the tangs
on either side of the leg with a rubber mallet.
2. Place the 12° baseboard bumper.
3.
Tap into place with a rubber mallet or press firmly
with the sole of your shoe until it locks into place.
Installation of Mattress Stop
Mattress Stops are designed to help keep the mattress
from sliding laterally and longitudinally on the mattress
support platform.
Installation Steps
Required tool - #2 Phillips screwdriver
1. Locate the screws at each corner of the inside
tube at the foot end of the mattress support
platform; one per side (Figure 9).
2. Remove the screws using the #2 Phillips
screwdriver; do not discard the screws.
3. Position and insert the mattress stops in the
holes provided (Figure 10). Reinstall the screws
removed in step 2.
4. Repeat at each corner of the head end of the
mattress support platform.
Figure 8
Figure 7
Figure 9
Figure 10