Joab EcoDrive, Руководство по эксплуатации и обслуживанию

Страница: 38 / 73

Fast Operation
To operate the fast tip function, first make sure that the extending-section is fully retracted and
the hydraulic lock is closed. Then simply press and hold button 4 down while operating the tip
function. Note, the radio controller can not operate fast operation, when tipping down.
Axle Weight Reading
The radio controller can be used to provide an approximate value for the
weight on an axle(s). Note, this is not a precise value and must be seen as an
indication of the actual weight only.
JOAB AB disclaims all responsibility if a vehicle is over weight, even if the radio
controller displays a value that is lower then the maximum allowed for the
vehicle.
The value displayed in the radio controller will normally be within ± 150 kg.
To activate the axle weight mode, press button 12 repeatedly, until a weight
scale is shown. To select which axles are included in the measurement, press
the respective buttons: 2, 4, 6, and 8 corresponding to the axle(s) that are to
be measured.
Each of the buttons (2, 4, 6, and 8) have two LEDs above them. These are
used to show which axles are selected and the status of the axles. The right
LED is illuminated red for axles that are selected, as shown. The left LED will
blink red whenever an axle is 0–500 kg less than the maximum allowed
weight. The left LED will constantly illuminate if an axle is over its allowed weight.
The LED above button 9 is used to indicate that it is the net weight that is displayed in the screen.
When the net weight is displayed, the LED is lit red. To change between the net weight and the
gross weight press button 9.
Charging
The charger for the radio controller is normally mounted
next to the driver's A-post inside the cab. Alternatively, it is
mounted in the driver's side toolbox, behind the door.
When not in use, always place the radio controller in its char-
ger. This will ensure that it is always fully loaded and ready
for operation.
To remove the radio controller from the charger, first pull
the bottom out a
small amount , approximately 10 mm, and
then push the controller up, as shown.
Do not pull the controller out from the bottom. This will
cause damage.
30
Radio Controllers | Operation
EcoDrive manual: 13300 Edition 1 | 2019-01-31