JNE TECH-D, Инструкция по эксплуатации

Страница: 13 / 25

___________________________________________________________________________
______________________________________________________________________________
13
TECH-D manual EN 2010-05-18.doc
2.9 Change out batteries
The digital circuit of the TECH-D measuring arm
is powered by 2 x AA 1.5 Volt batteries.
Batteries should be changed out when the
digital display begins to flash. It is
recommended that both batteries be replaced
and that the old batteries be disposed of in
accordance with local hazardous waste disposal
regulations.
Batteries are located in a hidden compartment
on the underside of the digital measuring head
(see photo). Battery cover latch can be released
by hand or small flat blade screwdriver.
NOTE!
Batteries should be installed according to the
diagram molded into the inside of the battery
compartment to ensure correct terminal polarity.
Do not use batteries with power ratings other
than 1.5 Volt as this can cause the equipment to
malfunction or damage the digital circuit.