JNE TECH-D, Инструкция по эксплуатации

Страница: 16 / 25

___________________________________________________________________________
______________________________________________________________________________
16
TECH-D manual EN 2010-05-18.doc
4.3 Length measuring
Before starting to measure it is important to
secure the setting of the measuring arm. This is
done by compressing the arm altogether and
pushing the ON/0 button until the display goes
off. With the measuring arm still compressed
push the ON/0 button and the digital number
900 (900mm) will appear. The measuring tool
will now measure according to this setting and
always start measuring from 900 mm.
If during measuring operations any doubt exists
about the function of the measuring arm, repeat
the above procedure.
1. Read the height dimension given on the
data sheet and select a suitable height
measuring rod and socket.
2. Push the height measuring rod and
adaptor into the measuring tool and set it
to the height dimension given on the data
sheet.
3. Mount the magnetic attachment in the
intended attachment point under the
vehicle. Pull out and adjust the
measuring tool so that the selected
measurement point can be reached.
It can be advantageous here to use the
hold feature to freeze the measurement
value, especially if it is difficult to see the
display while measuring. Press the
HOLD button briefly to freeze the
measurement value. To return, press the
HOLD button again briefly.
4. Read the measuring arm’s display and
compare the length measurement value
with the value on the data sheet. (No 1
and 4)
It can be advantageous here to enter the measured value in the data sheet table in
order to create a before or after report.
Repeat the same procedure on the other side
of the vehicle’s corresponding and selected length measurement point.
Note that the vehicle can have different measurement values for the right and left
side, depending on the design of the vehicle.