JNE TECH-D, Инструкция по эксплуатации

Страница: 11 / 25

___________________________________________________________________________
______________________________________________________________________________
11
TECH-D manual EN 2010-05-18.doc
PARTS INCLUDED
2.3 Height level rods
HEIGHT LEVEL RODS
The measuring tool includes 2 height level rods
in two different lengths.
2.4 Magnet attachment
MAGNET ATTACHMENT Ø35 OCH Ø60
This attachment is developed to suit most
vehicle models on the market.
Use it when a round or oval hole <Ø35 mm is
specified as the zero point on the vehicle
dimension data sheet.
2.5 Height measuring rods
HEIGHT MEASURING RODS
3 rods are included.
Rod length is determined by the data sheet and
should allow for the specified reading to be
observed when the rod has been locked in place
on the measuring arm.
Insert the rod into the measuring head at the
front end of the measuring arm. Position the flat
side of the rod towards the “release” mark, set it
at the desired height and secure by twisting it to
the “lock” position.
2.6 Level
LEVEL
On the measuring head is a level for comparing
divergences in height.