JLG 100HX, Операторы и безопасность

Страница: 29 / 80

SECTION 2 - PREPARATION AND INSPECTION
3120889 – JLG Lift – 2-11
2. Load Management System.
110HX.
NOTE: The blue light should illuminate when the ignition is
turned on.
a. Activate the hydraulic system from the ground
controls. The blue light should illuminate when
the SELECT SWITCH is in the ground position
and the EMERGENCY STOP switch is in the ON
position.
b. Extend the boom at horizontal until the yellow
band on the inner mid section is exposed from
the base. The yellow light should illuminate at
this point.
c. Continue extending the boom until the red mark-
ing band on the inner mid section is exposed
from the base section. The red light should illu-
minate at this point.
d. Continue extending the boom until the white
m ark ing b an d o n th e in n er m id sec tio n is
exposed from the base section. The red light
should blink and an audible alarm sound. Also
the telescope out and lift down will not function
in this mode.
IF BOOM CONTINUES TO TELESCOPE BEYOND THE THIRD
MARKING BAND, RETRACT THE BOOM, IMMEDIATELY SHUT
DOWN MACHINE AND CONTACT A QUALIFIED SERVICE PER-
SON.
100HX + 10.
NOTE: The blue light should illuminate when the ignition is
turned on.
a. Activate the hydraulic system from the ground
controls. The blue light should illuminate when
the SELECT SWITCH is in the ground position
and the EMERGENCY STOP switch is in the ON
position.
b. Extend the boom until the red marking band on
the inner mid section is exposed from the base
section. The red light should illuminate at this
point.
c. Continue extending the boom until the white
m ark ing b and o n th e in n er m id sec tio n is
exposed from the base section. The red light
should blink and an audible alarm sound. Also
the telescope out and lift down will not function
in this mode.
IF BOOM CONTINUES TO TELESCOPE BEYOND SECOND MARK-
ING BAND, RETRACT THE BOOM, IMMEDIATELY SHUT DOWN
MACHINE AND CONTACT A QUALIFIED SERVICE PERSON.
110HX/100HX+ 10.
a. With the boom fully retracted, raise the boom to
horizontal.
b. Position the toggle switch located on the right
side of the ground control box to the P position
and hold.
c. Extend the boom until it stops. The boom must
stop on the white band on the mid boom sec-
tion. Release the toggle switch.
d. Retract the boom until tele out will function. The
system is now reset.
e. Position the toggle switch to the M position and
hold.
f. Extend the boom until it stops. The boom must
stop on the white band on the mid boom sec-
tion.
32 Boom Chains N/A Chain Lube/Hot Oil Dip 1200 Includes extend and retract chains
33
Turntable Pivot Pin
2 Grease Fittings MPG - Pressure Gun 150
34 Extend-A-Reach Link Attach Pin 1 Grease Fitting MPG - Pressure Gun 150
35
Extend-A-Reach Pivot Pin
2 Grease Fittings MPG - Pressure Gun 150
NOTES: Key to Lubricants:
EO
EPGL
HO
MPG t Engine Oil
Extreme Pressure Gear Lube
Hydraulic Fluid (Mobil #424 or equivalent)
Multi-Purpose Grease
Table 2-1. Lubrication Chart
Components
Number/Type
Lube Points
Lube & Method
Interval
Hours
Comments
Courtesy of Crane.Market