To complete shut off power to the treadmill, turn off
master power switch and unplug from outlet .
ERROR MESSAGE & TROUBLE SHOOTING
E1 (Error 1):
When the machine starts but computer could not read the signal from sensor for 7 seconds,
E1 will be shown on the computer.
E6 (Error 6):
When the machine starts but computer could not read the VR signal from incline motor for 6 seconds,
E6 will be shown on the computer.
If any above trouble happens, please consult the distributor.
E3 (Error 3):
It happens only in HRC mode (H1, H2, or H3) when user
’
s heart rate is 20 beats more than target heart rate
and last for over 30 seconds. For your safety, you should stop running when E3 appears.
SMELL
If any smell comes out from motor, please firstly spray out some silicone on the running board (Please refer
to page : RUNNING BOARD MAINTENANCE), and see if the situation improves. Then consult the distribu-
tor for necessary help.
Lift the rear end of the frame to the computer till you hear a
"CLICK" sound from cylinder then push and pull it to make sure
the frame is fixed .
There is a safety pin on the air-shock . To fold down the
frame, please hold your hand on the frame (do not hold on
the crossbar of incline mechanism) and use your foot to
push at the center of air shock (as photo shown) then lean
down the frame into the ground .
WARNING
TO AVOID ANY DANGER HAPPENS TO CHILDREN,
PLEASE NOTE:
• DO NOT ALLOW CHILDREN TO USE THE MACHINE ALONE.
• TURNING OFF MASTER POWER SWITCH AND UNPLUG POWER CABLE FROM OUTLET
WHEN NOT IN USE.
• FOR SAFETY REASON, ALWAYS KEEP THE CHILDREN AWAY FROM FOLDING AREA
MASTER POWER SWITCH LOCATION
HOW TO FOLD UP FOR STORAGE
HOW TO FOLD DOWN FOR EXERCISE
20
