Jetmaster SLOW COMBUSTION, Инструкция по установке и эксплуатации

Страница: 7 / 24

SLOW COMBUSTION FIREPLACE INSTALLATION AND OPERATION INSTRUCTIONS
NOTE: A space of at least 30mm must always be left underneath the unit.
EXAMPLE: If the unit is build in at a height of 2 bricks from the floor level, a gap of approximately
130mm will be left underneath the unit.
NOTE: If the unit is build in at only 1 brick level above floor, special care should be taken to ensure
that the floor secreting, tiling and hearth, dos not reduce the air gap underneath the fame to less than
30mm.
Hearth
Heat is radiated from the bottom of this fireplace. It is therefore important to ensure that the fireplace
is installed on a non-combustible surface.
A popular example of such a surface is a floor, tiled with ceramic tiles.
Do not install this unit directly onto wooden or carpet floors. For these areas a non-combustible
hearth must be placed underneath the unit.
A popular example of such a hearth is a marble, or granite slab
The size of the heart must cover at least the area underneath the unit with a border of 100mm all
round and 200mm in front of the unit as shown in the pictures below.
Roof / ceiling influence
It is important to take into account all requirements for the flue height, flue protection and the flue
termination, before making a final decision on the location of the fireplace in the room.
NOTE: First read the rest of this manual before starting the installation
100
100
200
100
200
5