Jetmaster SLOW COMBUSTION, Инструкция по установке и эксплуатации

Страница: 21 / 24

SLOW COMBUSTION FIREPLACE INSTALLATION AND OPERATION INSTRUCTIONS
The outside of the unit
The outer surfaces of the unit can be cleaned using a soft moist cloth. When necessary, general
purpose household cleaners can be used to remove dirt.
Always ensure that the unit is dry, after cleaning. Excessive moistened areas, or areas where water
might have collected, must be avoided at all times to limit the possibility for corrosion. If necessary,
light a fire in the unit, so that it can heat up and all moisture can be driven away.
All exposed surfaces should be inspected for corrosion with regular intervals. In coastal areas
inspections should be more often. Such intervals should never be longer that 1 year.
All corrosion must be repaired immediately, by sanding down the corroded areas, and touching up
wit heat resistant paint supplied by Jetmaster.
NOTE: All flue pipes and components that is exposed outdoors, should be painted with a heat
resistant enamel paint.
The inside of the unit
It is recommended that the inside of the unit be touched up, after each winter season.
Clean out all ashes, using a vacuum cleaner for the finer dust. Wipe the inside using a soft moist
cloth.
Properly dry the complete inside. All exposed metal surfaces can now be touched in with the
Jetmaster heat resistant paint.
Chimney
The amount of soot, creosote and even condensed water vapours that collects inside the flue pipe will
vary depending on many factors, including, weather conditions, type of wood, an the method of
operation.
Conditions can occur, that would cause these deposits to ignite and to cause a “chimney fire”. This
should always be avoided, and it is therefore important to maintain a clean flue pipe.
It is recommended that the chimney be checked / swept annually.
19