Jepson 9435 T3, Руководство по эксплуатации

Страница: 13 / 124

EN
DE
FR
NL
ES
PT
PL
IT
DMC 9410ND
13. FUNCTION
13.1. PURPOSE
WARNING: The machine should not be
modified or changed, such as for a
different type of use, as specified in this
manual. The user is liable for any
damages or injuries caused by improper use.
The DRY MITER CUTTER 9410ND is suitable for
cutting strips, tubes and profiles made of steel,
copper, brass, aluminum, plastic and composite
materials.
13.2. UNPACKING
Remove the machine and all loose parts from the
box. Keep all packaging materials until you have
checked the machine and have satisfied taken into
operation.
1. DRY MITER CUTTER
2. Saw blade 255/60T
3. “K” clamping system for pipes
4. Vice
5. Allen key
Start to work with the machine only after you have
read these operating instructions carefully and
understood. From the factory side already set is the
cutting depth and the pivot point (distance from
the sliding stop motor spindle) See table sliding
stop marker on the circular saw table.
For transportation
purposes, the rear
clamping jaw is
mounted in the
rearmost position. In
order to achieve the
maximum working
space of +/- 45°, the
clamping system must be adjusted. To do this,
slightly loosen the 4 screws with which the rear
clamping jaw is fixed. The rear clamping jaw is then
pushed into the foremost position and fixed again.
(1) (2) Note: The
machine is
delivered from
the factory with a
table insert (1).
The saw groove (2) must be made by the user with
the first cut. The machine must be set to the 90 °
position for this.
13.3. FIXATION
For stationary use of the saw
fixation holes are provided for
fixing the saw, respectively two in
the front and rear area.
13.4. FITTING THE SAW BLADE / BLADE
CHANGE
Unplug from the socket.
Remove screw # 1 on saw
protection and remove protection
cover and place back.
Push the spindle lock and rotate
blade until it clicks (transmission is
blocked)
(1) (3) (2)
Blade screw with the Allen wrench in the direction
of rotation out to the right (1) Remove the flange (2)
and remove the blade. (3)
Place the new blade on the spindle and make
sure that the displayed rotation on the blade is
clockwise. Place the flange on the spindle and
tighten the Allen screw in clockwise rotation again.
Put the protection cover back in
place and tighten the screws.
WARNING: After changing of saw blade
always make absolutely sure that the
spindle lock is release to prevent any
transmission damage!
DMC 9410ND
13