Two people should be utilized to install each of the four marquee
and logo boards. One person should hold the assembly while the
other person lines up the bolts with the holes in the cabinet. Be sure
that all wires on the back side are pulled to the front so that they do
not get pinched between the cabinet - this will result in you having
to remove the panel to free the wire. Note the color of the graphic
on the header should match the color of that side of the cabinet.
Red on Red
It may be necessary to again lift the cabinet header to ensure it fits
snuggly into position and is not angled in any fashion.
Check Box When This Step is Complete
Checking the level of the header cabinet
Check all four sides to ensure that the cabinet header is flush across
the bottom. This ensures a good seal and will keep the snow from
blowing out.
Check Box When This Step is Complete
Step # 5
Installing the marquee and logo board
Step # 4-R
Installing the header cabinet
Check Box When This Step is Complete
Step # 4-S
INSTALLATION INSTRUCTIONS
Jennison Entertainment Technologies
Snow Down Service Manual
Page 23