10
Hollywood Reels™ • Copyright 2008 • Jennison Entertainment Technologies • All Rights Reserved
Star Installation
Remove both stars from the protective packaging. Open the included hardware bag. It is recommended to have
at least two people assist with the installation of these stars.
1.
Locate the two open areas on the top portion of the cabinet. Ensure that power cords are pulled through
the holes.
2.
Locate the two drilled holes on the rear of the cabinet and insert both bolts through these two holes
3.
Place the plastic spacer onto both bolts.
4.
Attach the metal bracket on the back of the star to the metal bracket attached to the game and connect
the power cord to the Star PCB.
5.
While one person holds the star, the other person should use a screwdriver to tighten the bolts. The bolts
should easily go into the holes on the rear of the star. NOTE: The person holding the star may have to
guide the bolts into the correct holes on the back of the star.
6.
Do not over tighten the bolts as this could strip the threads and reduce the effectiveness of the bolts.
7.
Repeat process with the other side.
Locate Power Wire
Attach Wire to Star
Insert Hardware & Spacers