10
SIDE BURNER HOSE QUICK DISCONNECT ASSEMBLY
Estimated Assembly Time: Approximately 5 minutes
Required Tools: Phillips Screwdriver
1. Insert the side burner hose with female sleeve through side panel of cart (Top drawing).
2. Push the sleeve of the female socket back and insert the male end of the connector. Release the sleeve
3. Push the male end into the socket until the sleeve snaps forward to lock the plug in place.
4. To disconnect, push the sleeve back and pull out the male end (bottom drawing).
WARNING
1. Attach the coupling half (socket) to the gas supply line in accordance with ANSI
Z223.1/NFPA 54 FUEL gas code.
2. Prior to inserting the plug, test the connection for leaks following the leak test instructions on
page 15. After the leak test is completed, rinse the connection with clean water to remove any
corrosive residue.
3. Do not use open flame to test for leaks.
QUICK DISCONNECT
1. Install the quick disconnect by pulling the spring Ring
downward on the female connector, insert the female
connector and release the spring ring.
2. a. After spring ring is released, male and female quick
disconnect will be locked together
b. Double check by slightly pulling the hose connector upward,
if not properly connected, hose will be detached. Do not use
excess pulling force; doing so may cause manifold and / or burner
Valve become off aligned.
3. Make sure all the connections are tightly secured by spraying
soapy solution. (Refer to leak testing section.)
Содержание 720-0513
Страница 13: ...13 COOKING GRIDDLE ASSEMBLY Insert the cooking grid into the fire box ...
Страница 44: ...44 Limited Warranty ...