Jenn-Air 720-0513, Руководство пользователя

Страница: 37 / 44

37
CARE & MAINTENANCE OF THE GRILL
STAINLESS STEEL
Grease specks can gather and bake onto the surfaces of the
stainless steel, giving the appearance of rust. For removal,
use an abrasive pad with a stainless steel cleaner.
GRILL RACK
The easiest way to clean the grill is immediately after cooking
is completed, and the flames have been turned off.
Wear a barbeque mitt to protect your hand from heat and
steam.
Scrub the hot grill by dipping a bristle barbecue brush in tap
water. Cleaning will be more difficult if the grill is allowed to
cool.
CAUTION
Before cleaning, make sure the gas supply and control
knobs are in the “OFF” position and the burners have
cooled.
GRILL BURNER CLEANING
1. Turn off the gas supply, and make sure the control
knobs are in the “OFF” position.
2. Make certain the grill is cool, and clean the exterior
of the burner with a wire brush. Use a metal scraper
for stubborn stains.
3. Clear clogged ports with a straightened paper clip.
Never use a wooden toothpick. It may break off and
clog the port.
4. Checking and cleaning burner / venturi tubes for
insects and insect nests. A clogged tube can lead to
a fire beneath the grill.
5. If insects or other obstructions are blocking the flow
of gas to the burner, call customer service at 1-800-
554-5799.
GRILL BURNERS
Extreme care should be taken when moving a burner.
It must be correctly centered on the orifice before any
attempt is made to relight the grill. Clean the burners
frequently and keep them clean at all time.
WARNING
Failure to properly place the burner over the
orifice could cause a fire to occur behind and
beneath the valve panel, thereby damaging the
grill and making it unsafe to operate.
GRILL BURNER REMOVAL/INSTALLATION
The grill burners are factory installed.
To remove the main burners for cleaning:
1.
Locate the nut at the rear of the burner on
the bottom side.
2. Remove the nut and lift the burner out of
the fire box.
3. To reinstall the main burners: Insert the
burner over the valve assembly
4. Insert the back of the burner into the hole
at the rear of the fire box and reinstall the
nut.
5. Make sure orifice spud is inside the
burners venturi as shown below.
GREASE TRAY CLEANING
The grease tray should be emptied, wiped down
and washed after each use with a mild detergent
and warm water solution.
A small amount of sand or cat litter may be placed
in the bottom of the grease tray to absorb the
grease. Check the grease tray frequently. Do not
allow excess grease to accumulate and flow out of
the grease tray.
CAUTION
1. Keep outdoor cooking gas appliance area clear
and free from combustible materials, gasoline and
other flammable vapors and liquids.
2. Do not obstructing the flow of combustible and
ventilation air.
3. Keep the ventilation openings of the cylinder
enclosure free and clear from debris