21
Troubleshooting
ISSUE:
Weapon doesn‘t react at all after battery connection.
SOLUTION:
Check if the battery is properly connected and charged. Also check motor
contacts and motor functionality. Check if the safety fuse hasn’t been blown.
ISSUE:
Weapon doesn‘t make shots after trigger pull (start-up vibration was made).
SOLUTION:
Damaged or misplaced sensor for trigger, check it‘s proper function.
ISSUE:
Selector is set to semi but act like on SAFE or AUTO (or any other combination).
SOLUTION:
Check the
right sticker position on the selector plate or clear dirt on this sen-
sor, check its proper function through „Sensor check“ in the app and use „Optical
selector calibration“ to set it again.
ISSUE:
Sector gear sensor is pressed after motor stop -> piston over traveling (Error 100).
SOLUTION:
Gun have too high rate of fire and piston make over spinning. Solve it by incre-
asing active brake or reducing pre-cocking (if used) or reducing rate of fire or use
battery with lower voltage or change gear ratio or use low speed high torgue motor.
ISSUE:
Selector plate has moved during shooting (Error 101).
SOLUTION:
You have changed by mistake fire selector during shooting or it was changed
by vibrations from shooting. Check and change if necessary the
right sticker positi-
on on the selector plate, and use „Optical selector calibration“ to set it again.
ISSUE:
Trigger is pressed during battery connection (Error 102).
SOLUTION:
Release the trigger and try again. Check for the right trigger sensor function.
ISSUE:
The gun always shoots BURST with short-long beep after fire (Error 103).
SOLUTION:
Cycle sensor doesn‘t detect sector gear motion. Clean the sensor from dirt.
check its right position in the gearbox to detect the gear cam and use „Optical cycle
calibration“ to set it again.
ISSUE:
High temperature on the mosfet (Error 104).
SOLUTION:
Wait until temperature will be dropped down. If it repeats, mosfet is overloa-
ded by too high Amps. Change gearbox internals to drain less amperage.
Содержание Leviathan V3
Страница 1: ...INSTALLATION MANUAL FOR GEARBOX V3 ...
