STARTING AND OPERATING
107
Enabling Four-Wheel Drive (4WD)
The buttons for the activation of four-wheel
drive are located on the Selec-Terrain switch
and allow you to select the following:
4WD LOCK
4WD LOW — (Trailhawk models only)
Active Drive Control — If Equipped
4WD LOCK Button
The Power Transfer Unit (PTU) is locked to
ensure immediate availability of torque to the
rear drive axles. This feature is selectable in
AUTO mode and automatic in the other driving
mode. 4WD LOCK can be enabled by the
following ways:
When the 4WD LOCK button is pushed.
When the Selec-Terrain switch is rotated
from AUTO to any other off-road modes.
Active Drive With Low Control —
(Trailhawk Models Only)
4WD LOW Button (Trailhawk)
The 4WD LOW mode helps to improve the
off-road performance in all modes. To enable
4WD LOW, please follow the steps below:
Enabling 4WD LOW
With the vehicle stationary, the ignition in RUN
mode or with the engine running, shift the
transmission into NEUTRAL and push the 4WD
LOW button once. The instrument cluster will
display the message "4WD LOW" once the shift
is complete.
NOTE:
Both LOCK and LOW LED lights will blink and
then become active on the Selec-Terrain
switch until the shift is complete.
The instrument cluster display will illuminate
the "4WD LOW" icon.
Disabling 4WD LOW
To disable the 4WD LOW mode, the vehicle
must be stationary and the transmission shifted
into NEUTRAL. Push the 4WD LOW button once.
4
21_BV_OM_EN_USC_t.book Page 107