JDS Uniphase OneExpert DSL, Руководство пользователя

Страница: 55 / 120

Chapter 4 DSL Testing
Connecting to the line
OneExpert DSL User’s Guide
April 2014 22052280, Revision 001
39
b Select Data Mode and then specify IPoE , PPPoE , or MultiVLAN . None turns the data
layer off.
c Select whether to do Automatic Login .
d Select MAC Address Mode and specify
factory default or user defined.
e Specify whether VLANs are used (a check mark indicates they are used).
f If VLANS are used, specify the following:
– Enter the VLAN ID and Priority .
– Select IP mode and then specify the network mode: IPv4, IPv6, or IPv4/IPv6 Dual Stack.
– Specify the network settings as described in “Specifying network profiles” step 2d to g
Press the Back/Cancel navigation key to return to the main screen.
Saving test profiles
After specifying the test settings, you can save them as a test profile.
To save test profiles
1 From the Setup & Tests screen, touch the Save button.
2 Enter a name for the profile.
3 Specify whether the profile will be shown on the Home screen
4 Touch Save .
The profile is saved.
Connecting to the line
The method used to connect to the line varies depending on the test mode and line configuration.
Connecting to a single twisted pair
To connect to a single twisted pair
1 Using the RJ-45 to telco clips cable, connect the RJ-45 to bed of nails test lead to the DSL
connector on the right panel of the OneExpert DSL.
2 Connect the RJ-45 to bed of nails test leads to the desired pair, black to tip(A) and red to
ring(B).
The line is connected.