JB-Lighting Sparx 18, Руководство по эксплуатации

Страница: 18 / 48

- 18 -
18
/
With RESET STEP you reset one step to its default values (DMX 000). The display shows STEP
NR: 1/X. Use the selection keys to select your step. CLEAR ALL resets the complete standalone
programming steps. Under MODIFY you will find STEP1/1 again. In the STANDALONE, TIME-
BASE menu item you have the possibility to change the Fade Time and Next Time from 1 second
to 1/10 second.
Starting the standalone program:
Call up the STANDALONE menu and navigate to the RUN submenu. Confirm the selection by
pressing the key combination “ENTER” (press and hold) and simultaneously “ESC”. The display
then shows: S-ALONE: 01/XX and the program runs in an endless loop.
Deactivation: Press and hold the “ESC” key and then also press "ENTER". The menu jumps back
one level and RUN appears in the display.
Accept the DMX values from an external console:
To accept the DMX values of a connected console, you must first enable the Capture DMX input.
To do this, go to the CAPT DMX menu item. The display now shows CAPTURE DMX 01/01, press
the Enter key to switch to STARTCAPTURE. The Sparx 18/30 now reacts to the signals from the
external console.
Operation via master-slave function:
Connect the Sparx 18/30 via DMX lines and activate the REMOTE menu item for all slave de-
vices. To do this, navigate in the STANDALONE menu to the REMOTE sub-menu. Activate the
REMOTE function by pressing and holding “ENTER”, and also pressing “ESC”. The spotlight is
in slave mode when the display shows the status REMOTE INACTIVE or REMOTE ACTIVE.
REMOTE INACTIVE: The Sparx 18/30 is in slave mode but does not receive a DMX signal.
REMOTE ACTIVE: The Sparx 18/30 is in slave mode and receives a DMX signal.
The master device is programmed via the MODIFY menu item and started via RUN (press and
hold “ENTER” and also press “ESC”).
From Spotlight Software 1.5 the standalone operation can also be programmed via the
App we offer.
4.7 INFO menu
The Info menu informs you about the respective software and firmware status, about the total
operating time, the LED operating time and the different temperatures of the spotlight. The first
two menu items in the Info area are the software version and the firmware version, where the
software version is an important source of information for our service requests, the firmware ver-
sion is a less important source of internal information. The TOT OPERATE TIME menu item can
be used to show the spotlight’s total operating time, TOT LAMP TIME can be used for the total
operating time of the LEDs and TOT BAT CHARGE TIME specifies the rechargeable battery's
complete charging time (rechargeable battery buffering). The three times cannot be deleted!