JB-Lighting Sparx 18, Руководство по эксплуатации

Страница: 16 / 48

- 16 -
18
/
4.2 FACTORY DEFAULTS - Factory settings
To reset the Sparx 18/30 to the factory settings, go to the menu item FACTORY DEFAULTS ->
LOAD DEFAULTS. After confirming the confirmation prompt SURE? with “ENTER”, all parame-
ters are reset to the factory settings. The current white balance (chapter 6.1) is retained during
the reset.
4.3 USER DEFAULTS - User settings
If the user has set the Sparx 18/30 in the PERSONALITY menu to their personal settings, these
can be saved and loaded in the USER DEFAULTS menu. In order to prevent unintentional alter-
ation of the data, you must enter the following password during the saving process: “JB-LIGHT-
ING”.
4.5 PERSONALITY - Personal settings
DMX MODE
The Sparx 18/30 has a 4 DMX modes (see channel assignment). Modes 1-3 are standard modes.
Mode1 can be used to operate all Sparx 18/30 parameters optimally and easily. Mode 2 is the
16-bit variant of Mode 1; most channels can be adjusted more finely here. In order to save DMX
channels, the Sparx 18/30 can be reduced to 22 channels in Mode 3. Mode 4 provides extended
programming options with 96 channels.
4.4 DMX / NET ADDR - DMX addressing / Artnet addressing
DMX addressing can be carried out either directly in the display. Set the desired DMX address
by pressing the “UP” or “DOWN” key. The value is confirmed with the “ENTER” key. DMX ad-
dressing can also be carried out within the menu item DMX / NET ADDR, and there under DMX
ADDRESS.
To set the Artnet address, go to the menu DMX / NET ADDR and select the menu item ARTNET
ADDRESS. You can now use the UP/DOWN keys to set the Artnet address. The Artnet address
is displayed in the format 000.00.00. This display corresponds to:
Network.subnetwork.universe.
DMX INPUT CONFIG
The WIRELESS and NETWORK options are available in this menu item.
WIRELESS -> ON/OFF can be used to activate or deactivate the factory-installed radio DMX
receiver module for the Lumen radio and WIRELESS -> UNLINK can be used to delete the con-
nection to the transmitter that is connected. In order to connect the spotlight to a transmitter, set
wireless to ON on the spotlight and press the connection button on the transmitter for a short
time. The transmitter now searches for all spotlights on which wireless is activated and spotlights
that are not connected to a transmitter. Once the Sparx 18/30 has connected to the transmitter
successfully, a level indicator on the display informs you of the current reception quality. If the
Sparx 18/30 is additionally connected via the DMX/etherCON sockets, these signals have prior-
ity over the radio link. You can press the ESC and DOWN key shortcut to log the spotlight out of
the transmitter that is logged in.
In NETWORK -> ARTNET, the spotlight’s IP address must be selected or set for Artnet operation.
Each spotlight has a one-time standard IP address. In ARTNET -> DEFAULT-IP, this can only be
changed from network 10.xxx.xxx.xxx to a network 2.xxx.xxx.xxx. A customer-specific IP ad-
dress can be set in ARTNET -> USER IP. This address is divided into BYTE1 to BYTE 4, which
can be set one after the other.