JB-Lighting P 12, Руководство по эксплуатации

Страница: 33 / 40

- 33 -
P12 Wash
7.2 Changing gobos
To open the device (from the right side) place
the spotlight on a firm base as shown in the
picture, the display (1) facing you, the tilt lock (2)
is on the right side and the spotlight head facing
away from you (3) (Or look through the grille into
the spotlight from behind and look at the arrow
showing the cover to be opened).
To lift off the cover, open the four camlocks by
half a turn, lift off the cover and unhook the safety
lanyard. Now open the two knurled screws (5)
and remove the gobo insert. The following figure
(1) shows the gobo insert of the P12 Wash.
WARNING: Disconnect fixture before opening!
!
11
22
3 3
5
To change the rotating gobos remove only the
clamping ring (A) with a pointed object replace the
gobo and then put the clamping ring again. When
installing glass gobos, make sure the white coated
side faces the front lens. Gobos that are not allowed
to twist, e.g. Logos are additionally recommended
to be secured against twisting with a drop of silicone
adhesive.
(1)
(2)
A
When inserting original gobos, pay attention to the markings on the gobo, the gobo holder and
the gobo wheel!
7.3 Gobo size
If you want to have your own gobos produced, please note the following dimensions:
Usable diameter, rotating gobowheel: 23.00mm
Outer diameter: 27.90 mm (+0/-0.1 mm)
Maximum thickness: 1.1 mm
23mm 27.9 mm