JB-Lighting P 12, Руководство по эксплуатации

Страница: 10 / 40

- 10 -
P12 Wash
The P12 Wash has a DMX-in and DMX-out connector. Now connect the DMX output of your
controller to the 1st P12 Wash (Controller DMX-Out -> P12 Wash DMX-In). Then the 1st P12
Wash with the 2nd P12 Wash (P12 Wash DMX-Out -> P12 Wash DMX-In) and so on. In some
cases it is advisable to insert a so-called end connector (XLR connector with a 120 Ohm
resistor between pin 2 and pin 3). Whether an end connector is required depends on various
factors, including the cable lengths used and the number of devices. However, as long as no
problems occur in the DMX line, this is not necessary.
4.4 Signal connections
The DMX cabling (signal lines) should be done with a 4-pin cable with shielding. We recommend
a DMX cable (110 Ohm, 4x0.22mm
2
), alternatively a 2-pole micro cable can be used. The plugs
and sockets are 5-pin XLR connectors, which can be purchased in specialist shops.
Pin assignment:
Pin1 = Ground/Shielding
Pin2 = DMX -
Pin3 = DMX +
Pin4 = not connected
Pin5 = not connected
1
2
3
4
5
1
2
3
4
5
Cable with shielding
4.4.1 DMX cabling
4.4.2 Ethernet cabling
Ethernet cabling can be done with standard network lines. The sockets on the device are Neutrik
etherCON sockets. Special cables with etherCON connectors are recommended by Neutrik. The
two sockets on the P12 Wash are connected to each other via a switch. Up to 10 devices can
be connected in series without any delay. Of course, the spotlights can also be supplied in a
star configuration via an external switch. The received signal can be output via DMX. To do this,
set the DMX OUTPUT CONFIG setting to ON in the PERSONALITY menu. After confirming with
ENTER, the spotlight emits the entire universe received via DMX.
4.4.3 Wireless reception
The P12 Wash is equipped as standard with a LumenRadio CRMX receiver for wireless DMX.
The receiver can process both DMX and RDM. If a cable and wireless connection are connected
to the P12 Wash, the cable connection has priority! The received signal can be output via DMX.
To do this, set the DMX OUTPUT CONFIG setting to ON in the PERSONALITY menu. After
confirming with ENTER, the spotlight emits the entire universe received via DMX.
ATTENTION: Make sure that there is no signal at the DMX input at the same time !!
!
ATTENTION: Make sure that there is no signal at the DMX input at the same time !!
!