AAA-055-00012
Jaylor Operator’s Manual
- 52 -
Single Auger Trailer Units
DRUM EXTENSION INSTALLATION (IF APPLICABLE)
Depending on the Jaylor model and options you have chosen, your machine may be equipped
with a plastic (HDPE) drum extension. If so, please follow these steps to install the extension on
your single auger machine:
1. Begin by unrolling the entire length of the HDPE extension. Measure the full length of the
section and mark the half way point. The section should be 38’ in length.
2. Line up the half way point of this section with the center of one of the v-panels (side panels), so
that the extension sits flush on the angle iron at the top of the drum. Make sure to choose the v-
panel opposite to the side you will be loading on. There will be overlap of the extension and this
overlap will add strength to the loading side (see Figure 18 below).
3. Using the holes in the angle iron as a guide, drill a hole (1/2” diameter) in the extension and
fasten to the angle iron at or near this point at the center of the v-panel. Make sure that bolt
heads sit on the outside of the extension.
4. Wrap the two ends around the angle iron as shown in Figure 18 below. First clamp the inside
end to the angle iron, making sure that the extension is pulled as tight as possible. Wrap the other
end so it overlaps the inner extension section and clamp together. Make sure this end is also as
tight as possible.
Figure 18 Securing Extension
6. Beginning just after the extension overlap (see Figure 18), start drilling and fastening the
plastic extension to the angle iron, using the predrilled angle iron holes as a guide. Move in one
direction around the drum.
7. Using the remaining hardware, drill and fasten a second row at the top of the overlapping
extension sections.
