AAA-055-00012
Jaylor Operator’s Manual
- 21 -
Single Auger Trailer Units
•
Re-torque all wheel nuts, fasteners, and hardware.
•
Check that auger turns freely.
•
Check the auger. Remove all string, twine, or other entangled material.
•
Proceed with normal servicing and maintenance schedule as defined in the Maintenance
Section.
EQUIPMENT MATCHING
The machine is designed to be used with Agricultural tractors. To ensure a good performance,
the following list of specifications must be met:
1. Horsepower:
The minimum horsepower that is
required for your Jaylor is explained in
the ‘Mixer Specifications’ located at the
end of this document.
2. Drawbar Dimensions:
a. The tractor drawbar dimension must
be set at
14 inches
between the end
of the shaft and drawbar pin hole
center for 540 RPM units for a
Standard Double Yoke
pto shaft.
b. The tractor drawbar must be set at
9.75” (250mm)
if the optional
Constant Velocity (CV)
pto is
supplied.
3. PTO Shaft:
The tractor PTO Shaft must meet the following specification:
540 RPM – 6-spline, 1-3/8” diameter.
Important: It is not recommended that shaft adaptors be used on the tractor shaft to prevent
operating at the wrong RPM.
4. Hydraulic System:
For front door discharge units, the tractor must be equipped with a minimum of 2 remote
hydraulic outlets with
5 GPM (19 L/min) at 2000 psi (13,750 kPa)
. One circuit is used to
power the unloading conveyor; the other circuit is used to supply hydraulic power to the door.
For center side door units, the tractor must be equipped with a minimum of 1 remote
hydraulic outlets with
5 GPM (19 L/min) at 2000 psi (13,750 kPa)
. This circuit is required to
supply hydraulic power to the discharge door.
5. Drawbar Attachment:
The machine is designed with a clevis type hitch. Always attach with the tractor drawbar
inside the clevis.
DRAWBAR
TRACTOR
PTO
Figure 2 - Drawbar Setting.
