Jay electronique Orion, Инструкция по установке и эксплуатации для пользователя

Страница: 99 / 176

- 99 -
Orion
- 324501G
DE FR EN
7.11- Receiver parameter erasing procedure
This procedure has the following effects :
• Erasing of all programmed transmitter(s) / receiver(s) associations,
• Erasing of all programmed interlockings,
• All relays operating mode turn by default mode : «Continuous
make contact».
 The receiver parameter erasing procedure is done from the receiver by
, and jumpers/microswitches.
Only the radio channel setting is preserved
1
ORRS and ORRA receivers : Switch off the receiver
ORRD receiver : the receiver can remain powered up throughout the procedure
2
ORRS and ORRA receivers : install the jumpers , and to
con fi gure the settings.
ORRD receiver : set the microswitches , and to the «ON»
position.
R2 R3 R4
V1 V2 V3
JP1 JP2 JP3
V1 V2 V3
JP1 JP2 JP3
JP4
V1 V3 V2
JP3
ON OFF
JP1
JP2
ORRS ORRA ORRD
3
ORRS and ORRA receivers : Switch on the receiver
ORRD receiver : go to the next step
4
V2
and
V3
ORRA
ORRS ORRD
LEDs fl ash 5 times during the parameter erasing, then
go off (except on ORRD DIN rail receiver, indicator lights stop to blink for a few
time and re-start to blink 5 times etc...).
All the receiver parameters (except the radio channel setting) are erased.
5
ORRS and ORRA receivers : switch off the receiver and remove the ,
and jumpers.
ORRD receiver : set the , and microswitches to the «OFF»
position.